1.With washing.miling.softening.drying all-in-one combined

2.Fabric drawn with low-tension, with good dimensional stability

3.Forced penetration of detergent,efficient washing,time-saving.

4.With no mechanical pressure on fabric,crease not easily emerge during washing process

5.With preparation tank for recycled lotion,less water and detergent use,environment-friendly

6.Physically softening,reduce the amount of softener

With no mechanical pressure on fabric,crease not easily emerge during washing process

Tailor-made cylinder in stainless steel, used to carry ropy fabric,with four slices at surface of cylinder, to enlarge the driving action to make the full displacement of fabric;under negative pressure and airflow pressure inside the cylinder,draw the fabric with no mechanical pressure,crease not easily emerge during washing process.

Even washing and improve washing effect

Spray atomized detergent solution evenly on the fabric,drive the fabric by high-speed airflow,much evener washing and improved washing efficiency.

Physically softening,reduce the amount of softener

Fabric carried by cylinder in high-speed,hit the tailor-made rear tube,through the collision emerge interaction force,disintegrate the fabric body and make it soft,reach obviously and lasting milling effect and higher softness level with less softener.

Direct drying inside machine with short time

Wet finishing combined with direct drying inside,make initial water-squeezing,without taking out the wet fabric from machine.Wind flow make the heated-air penetrate the fabric and expel wet air in time,shorten the dringleadtime.

Environment friendly and energy saving

Cycle preparation tank and inner roller device,without dehydration outside tank,this system can recycle use the soap liquid or other assitant,also can shorten the drying time.Assistant and lotion been sprayed on fabric through forced cycle,with efficient washing.Compared with the traditional process,washing time shortened by 70%,water saved by 50% for washing 1ton of fabric,steam consumption reduced by 30% maximum.with two airflow passages,reduce the wind drag and save electricity.

It can shorten the subsequent process time of wool textile production

The wool fabric have a preliminary milling function through bumping,so subsequent milling process will be easier,can reduce 30% milling time; for the reason of the twist of the yarn is reduced,so it is easier to fuzzing,will decreased 1-2 times fuzzing. 

number	item	Parameter
1	input power	Three phase five line，380V±10%，50Hz
2	installed power	about 102kW
3	power supply of Operation panel	24V
4	working speed	0—1100m/min，adjustable power
5	Fabric maximum capacity	350kg
6	demensions	5582x5447x5744mm（L×W×H）
7	intake pressure	0.2MPa
8	compressed air pressure	0.4—0.8 MPa
9	steam pressure	0.4—0.85 MPa
10	Highest finishing temperature	160℃
11	fan flow	40000 cm3/h
12	total weight	about 12 tons
13	Safety of equipment	meet the GB5226 Electrical safety standard